Heat-Recovery Type Hot Air Drying System
TAKUBO ANALECTS
Fuel cost of the Heat-Recovery Type Drying System is much cheaper than the conventional electrical or direct-fired systems because the system reuses heat from the combustion chamber without waste.
The gasese produced by combustion are vented out of the drying oven and enter a heat exchanger and, together with fresh air from outside.
Tkubo's ［DRY TEC］ is the original Heat-Recovery Type Hot Air Drying System to realize Superior Economy, Safety and Finishing.
DRY TEC has lots of advantages in safety and quality by using the features of the Heat-Recovery Type Hot Air Drying System. It has been the longtime seller product of Takubo since 1975 as well as OIL BOOTH.
Superior Economy
Reusing waste heat, and amazing low mileage
Fuel cost of the Heat-Recovery Type Drying System is much cheaper than the conventional electrical or direct-fired systems because the system reuses heat from the combustion chamber without waste.
High Safety
Indirect heating system with high safety
Drying oven and combustion chamber are completely seperated because an indirect heating system is used. Combustion gases never get into the drying oven.
Even if a gas leak and incomplete combustion occur, the exhaust fan will exhaust it outside a furnace forcibly.
5m3 /m Exchange of the air in the oven
Air circulation of the Heat-Recovery System exchanges the interior air for outside fresh air by 5m3/m. It takes only 1 minute to complete the air-exchanging in the oven.
Some volatile substances from the works are exhausted to the outside by the air circulation so that it hardly reaches to the dangerous zone in the oven.
High Quality
Excellent exhaust system makes it possible to avoid any adverse effects on the coating layer, which determines the quality of the finish.
Combustion gases are exhausted to the outside completely so that any water and volitile substances from the fuel never remain in the oven.
Haze, Uneven Coating and Crimp caused by gases are prevented. The intalke air has no dust because of the filter.
It always provides the best performance of the coating material by the fresh and clean hot-air.
Solvents of the coating material evaporate in drying. If the conbustion gases have some water in the conventional drying oven, the solvents will intake some water in evaporating. This is the casue of Blushing. In DRY TEC, tne conbustion gases never come into the inside of oven , so the bad phenomenon such as Blushing never occur.
