Data creation
Improvement of the robot teaching efficiency
Robot teaching without any programming languages
PACK teaching software, TAKUBO ENGINEERING Original Teaching Software, is equipped in the coating robots of SOFTBOY PRO series. Because any input by robotic programming language is not required, this is an extremely easy software, in which you register only the points of S (Start point), W (Return point (spray width)), and D (Depth point (size of the plane face).
Easy point registration with only 2 to 4 points
Operability of teaching
Operation by PC
- Easy data copy & paste
- Easy data management
- Registration of work pictures and record of coating conditions
- ※One group can hold 500 data
- ※Up to 21 groups are available
- ※Data capacity: Flash media of 4G is attached as standard equipment
Easy track data creation by point-registration
3-point teaching
Painting plane is settled by inputting the 3 points, which are S (Start point) to start coating, W (Return point, direction of coating) to set the coating width and D point to set size of the coating plane, in the 3-point teaching. In case that W point is the same position as D point, it is recognized as a straight line instead of a flat surface. Although this 2-point teaching is mostly used in creating spindle coating data, 3-point teaching is necessary for coating with curves because of coating direction.
4-point teaching
4-point teaching is used to coat the surface such as trapezoid or diamond. There is a restriction about track type, that is, only 2 selection of straight line or zigzag coating. It is not used for revolving coating.
Variety of motion types
3 robot track types from straight line to curve
- Straight line: Selection in Right angle or Zigzag, with Gun swing or without Gun swing or Special
- Polygonal line: Selection in Right angle or Zigzag, with Gun swing or without Gun swing or Special
- Curve: Selection in Right angle or Zigzag, with Gun swing or without Gun swing or Special
Specification of pitch
SW interval
Distance displayed in SW interval indicates the distance between S point and W point which are inputted in 3-point teaching.
WD interval
It indicates the distance between the two points of W and D.
P (Pitch interval)
Width of the dotted lines is indicated.
公開日：2017年4月10日
