Up-load of the page for Custom-made DRY TEC, Drying Device exclusively for Coating
Special Order Large-sized Drying Device, GO-503050
GO-503050 : Internal dimensions W:5000mm X H:3000mm X D:5000mm It is a Special specification available for even large-sized articles. Small-quantity or small-sized articles are also available with internal partition to divide the oven space into half. Waste of energy cost is reduced so that rational coating is realized.
DRY TEC is indirect-heating hot-air method. Considering safety, energy loss is restrained because the exhaust heat is reused and recovered by our original heat exchange system with about 85% of heat recovery rate. It has a quick starting with a very good fuel-efficiency. Performance of the paint is enhanced at the maximum to improve the quality since fresh air of 30m3/min is supplied.
→ To the page for Custom-made DRY TEC, GO-503050